Openpilot: Revolution (Revo)

The Revolution is an autopilot for multirotors, helicopters and fixed wings. It is a full 10DOF with magnetometer, gyroscopic, accelerometer and pressure sensors.

The OpenPilot Revolution is based around the STM32F4, OpenPilot was the first Open Source UAV project to adopt the STM32 Micro Processor and helped bring the hobby in to the 32bit micro-controller age, moving to new the F4 line was an obvious choice and this is the path we have taken.

At it's heart, the Revolution has a STM32F4 processor with 1 Megabyte of flash storage space, 192 Kilobytes of ram, it runs at 168Mhz it also includes hardware support for floating point instructions which enable very fast calculation of Kalman and Complementary filters.

Compared to the STM32F1 used in the CC3D, the F4 processor in the Revolution runs significantly faster. While the CC3D has some available capability for code expansion, it is quite limited. The move to the F4 dramatically increases what is possible and the power that is available to developers.

naja mal schaun was das teil kostet

- CC3D "Kickstarter" zum halben Preis

The Revolution has it’s own OPLink Mini built right onto the board! This is not only a 10DoF flight controller with an ST32F4 processor in the same small footprint as the CC3D but also has it’s own LRS modem. The modem is directly powered from the Revolution itself so you don't need to worry about any additional power supply.
Of course, the on-board modem will have the same functionality as the OPLink Mini, both are fully configurable from the GCS.
Operating on the 433MHz band (a 900Mhz version will be released at a later date), the modem provides a direct telemetry link between the GCS and your flight controller. And just as with the OPLink Mini, you can adjust the output RF power for compliance with any governmental RF regulations, or it can be disabled entirely.

The ability to use the on-board OPLink Mini modem as either a telemetry link, RC link, or both makes for a powerful and flexible flight platform!

Das mag in manch kaufmännischer Kalkulation ein halber Preis sein. Legt man allerdings ernsthafte Mathemathik zu Grunde,
dann ist der Preis um 22,4% gesunken. (von 89 AUD auf 69 AUD)

Also..... das neue Revo (99 AUD) + 2 x OPLink ( a 35AUD) plus Versand ( 28 AUD).....in Summe 198 AUD sind ca. 165€

Also..... das neue Revo (99 AUD) + 2 x OPLink ( a 35AUD) plus Versand ( 28 AUD).....in Summe 198 AUD sind ca. 165€

Du benötigst aber eigentlich nur ein OpLink, da das 2te auf dem Revo schon drauf ist.

Ich würde folgendes bestellen:

1 Revo
1 GPS
1 OpLink

Tschö
JR

Sprich RC Empfänger mit Telemetrie auf der Platine (bei selber größe wie die CC3D). Aber sehr wahrscheinlich illegal in DE.